tubular bathroom towel radiator
- by mic - 1/4/2011 - 12:56:10 pm Time: 33 mins 4 secs collaborative drawing open to everybody
v1- by mic - 1/4/2011 12:56:10 pm
Time: 33 mins 4 secs
Time: 33 mins 4 secs
mic1/4/2011 1:13:43 pm
1)air vent
2)towel peg
3)big towel peg
4)regulation vent and connection to piping
5)toilet roll holder
will be made of 22 mm diameter copper piping, on a bathroom wall
any design welcome, corners must be 90 or 45, T branches can be used. cant be too complicated, overall size max cca 0,9 x 1,8 m (WxH)
i want it to look robotic and/or mixed with some animalcreature or a spaceship. haha.
thanks!
2)towel peg
3)big towel peg
4)regulation vent and connection to piping
5)toilet roll holder
will be made of 22 mm diameter copper piping, on a bathroom wall
any design welcome, corners must be 90 or 45, T branches can be used. cant be too complicated, overall size max cca 0,9 x 1,8 m (WxH)
i want it to look robotic and/or mixed with some animalcreature or a spaceship. haha.
thanks!
Shunt1/5/2011 8:05:42 am
I have to operate a Dynobend tube-bending machine at work. If you wish, I could bend a test version of this.
Assuming the line 5) is actually the size of a regular toilet roll holder I don't even need the measures.
I only doubt if there's a standard width of toilet rolls, or if there are European/Asian/American variations.
Are the connections going to be welded or screwed?
Assuming the line 5) is actually the size of a regular toilet roll holder I don't even need the measures.
I only doubt if there's a standard width of toilet rolls, or if there are European/Asian/American variations.
Are the connections going to be welded or screwed?